INTRODUCTION:
This machine can
assembly the upper and downward caps and PCB switch
automatically. Then the assembled parts move to Ultrasonic
Welding Station. After welding is completed, the welded
parts then move to Check Station. The entire process
is automatic. No operators is needed for inserting
and assembling unwelded parts.
- This welder is suitable for welding
different kinds of transformers by replacing suitable
component holders.
- Equipped with electric heating printing
device to stamp manufacturing date and lot number.
-
Operating method: Put the transformer
to be welded on the component holder, automatic feeding,
welding, thermal printing, end product ejection.
ADVANTAGES:
-
Automatical welding process. The welding machine
can divide welded parts into good and bad parts. the
bad welded parts will be ejected from Bad Parts Funnel
before move to Check Station.
-
Equipped with RINCO PCSII generator which controls:
(1) Downward stroke depth with optical meter; accuracy
0.01mm, (2) Maximum and Minimum of welding energy,
(3) Welding time; accuracy 0.01s. When the actual measurements
are higher or lower than the setup limits of above-mentioned
parameters, the generator will send out error messanges
to PLC. By this, the good and bad welded parts are
divided into different groups. The welding data can
be stored.
-
12 station index and speed-adjustable motor are adapted
to connect to the assembly machinery. Once the accembly
machinery is error, the welding machine can still work
with manual feeding assembled parts.
-
Touch type PLC interface is used to control all movements
of this machine.
-
Equipped with RINCO MP3512 ultrasonic press machine,
the welding travel can be adjusted precisely. Accuracy
0.01mm.
FREQUENCY/
OUTPUT: 35KHZ/
900w
CAPACITY: 20~35
pcs./min. |
